Line Recessed Floor LED Tape Extrusion Profile

The Line Recessed Extrusion Profile comes in different lengths and is used to house our LED tape, which keeps the LED tape safe and out of the way.

For Exterior Use - mounting to different types of pavements, floor, outdoor grounds, sidewalk surfaces, bike lanes, parking lots etc. (designed to meet IP67 waterproof level)

HR-LINE frosted cover and densely spaced LEDs inside the extrusion will provide an effect of an even line of light. Due to its high integrity and high load bearing capacity, the extrusion is ideal for high-traffic areas such as sidewalks, bike paths, environment friendly.

• Designed to obtain an IP67 waterproof rating
• Designed to reach IK10 degree of protection against mechanical impact
• Resistant to pedestrian and road traffic

Extrusions

As many lengths of extrusion can be used as is desired. Any piece can be positioned end to end with each other to make an unlimited distance.

Endcap

An Endcap is required for each circuit of extrusions being used. It is positioned on the end of the very last extrusion in the circuit and is used to stop dust from and moisture from interfering with the electrical components.

Powerend

An Powerend is required for each circuit of extrusions being used. It is positioned on the very first extrusion in the circuit and serves the same purpose as the Endcap. The powerend has a hole In the centre which allows a cable to be fed through to power the strips.

Diffuser

A diffuser is used to give the light a more even blend. Simply purchase the same amount of diffusers as you did with extrusions.

Will fit any tape with a maximum width of 10mm.